BLOG

Home  > INFO CENTER  > BLOG  > 

Automatic Water Pump Controller Manual and Troubleshooting

Automatic Water Pump Controller Manual and Troubleshooting

2020-06-16


You known, the automatic water pump controller is one of the important accessories for water pump, which controls start and stop of the pump when any tap or valve of the system is opened or closed. Today, we will share you something about its installation and troubleshooting.


Automatic Water Pump Controller Manual

 

First, in order to ensure the normal operation of the automatic water pump controller, please check whether the input and output wiring and the probe connection cable are reliable after installation. The probe can be moved up and down to make it contact and disengage from the water surface, and simulate whether the water pump controller is installed correctly and can work normally according to your needs.

 

Second, it is recommended to fix the probes at various points on the inner wall of the pool to avoid misalignment of the probe position and cause the water level controller to malfunction. The automatic water pump controller is not working properly.

 

Third, after connecting according to the above wiring method, check the "manual/automatic" water pump automatic electronic control switch on the right side of the product. Whether the water pump can be turned on and off manually according to user needs, and adjust it to the "automatic" position after use , the automatic water pump controller enters the working state.

 

Fourth, the water pump needs to be turned on and off temporarily. Please use the "manual/automatic" switch control (DF-96D) type without manual switch on the left side of the automatic water pump controller.

 

Firth, to avoid misoperation, please do not install the automatic water pump controller in the environment of moisture, corrosion and high metal content gas.

 

Lastly, it is recommended that you use the special probe for automatic water pump controller produced by the professional water pump supplier.


               

Automatic Electronic Switch Pressure Controller For Water Pump JTDS-1

               

Automatic Electronic Switch Water Pump Control with Pressure Gauge JTDS-8

               

Automatic Electronic Switch Pressure Controller with Pressure Gauge JTDS-2

 

Automatic water pump controller troubleshooting

 

First, The power supply does not work:

 

a. Check whether the red power indicator light is on, if not, check whether the input and output terminals are in good contact;

 

b. Check whether the "manual/automatic" water pump automatic electronic control switch on the left side of the product is adjusted to the "automatic" position on "off", and the automatic water pump pressure controller enters the working state.

 

Second, The water level line is above or below the probe control point, the water pump is not automatically turned off or turned on, please press the "Auto/Manual" water pump automatic electronic control switch to manually control the water pump. And check:

 

a. Whether the probe deviates from the original position, and the placement position is too high (too low), so that the water level cannot be contacted (detached);

 

b. Whether the connection of the upper and lower water level wires and the ground wire probe is misaligned with other wires, whether there is a wrong connection or short circuit;

 

c. Whether the probe has rust and shedding phenomenon, whether the connection between the probe cable and the product, the probe cable and the probe is in good contact;

 

d. Whether the ground wire at point C has been placed at the lowest position of the pool.


Chat Online 编辑模式下无法使用
Chat Online inputting...